|
|
|
controller xtc0 at vme16d16 ? csr 0xee60 priority 3 vector xtintr 0x64 controller xtc1 at vme16d16 ? csr 0xee68 priority 3 vector xtintr 0x65 tape xt0 at xtc0 drive 0 flags 1 tape xt1 at xtc1 drive 0 flags 1
The Xylogics 472 tape controller controls Pertec-interface 1/2'' tape drives such as the Fujitsu M2444 and the CDC Keystone III, providing a standard tape interface to the device see mtio.4 This controller is used to support high speed or high density drives, which are not supported effectively by the older Tapemaster controller (see tm.4s
The flags field is used to control remote density select operation: a 0 specifies no remote density selection is to be attempted, a 1 specifies that the Pertec density-select line is used to toggle between high and low density; a 2 specifies that the Pertec speed-select line is used to toggle between high and low density. The default is 1, which is appropriate for the Fujitsu M2444, the CDC Keystone III (92185) and the Telex 9250. In no case will the controller select among more than 2 densities.
The xt driver supports the character device interface.
The user will be notified of end of tape (EOT) on write by a 0 byte count returned the first time this is attempted. This write must be retried by the user. Subsequent writes will be successful until the tape winds off the reel. Read past EOT is transparent to the user.
Not all devices support all ioctls. The driver returns an ENOTTY error on unsupported ioctls.
1/2'' tape devices do not support the tape retension function.
Record sizes are restricted to an even number of bytes.
Absolute file positioning is not fully supported; it is only meant to be used by suninstall.8
|
|
|
Created by unroff & hp-tools. © somebody (See intro for details). All Rights Reserved. Last modified 11/5/97